Simpson 13SIE-170 Manual De Instrucciones página 8

NOTE: The power supply must be 120 V, 60 Hz and a minimum 15 amp dedicated
circuit.
A. Inspect cord before using. Do not use if cord is damaged.
B. Keep all connections dry and off the ground.
C. Do not touch plug with wet hands.
D. The pressure washer is provided with a ground fault circuit interrupter built into
the power plug.
If replacement of the plug or cord is needed, use only identical replacement parts.
Contact customer service for proper replacement parts.
WARNING: Test GFCI before each use. DO NOT use pressure washer if test
below fails.
gFCI Test Procedures:
1. Plug GFCI into power receptacle.
Indicator light should illuminate.
2. Press test button (X). Light should
turn off.
3. Press reset button (W) for use.
Indicator light should illuminate.
Do not use if above test fails.
NOTE: The GFCI must be reset each
time the pressure washer is connected to an electrical outlet. Reset by simply
pushing the reset button on the GFCI power plug.
EXTENSION CORDS
Use only extension cords that are intended for outdoor use. These extension cords
are identified by a marking "Acceptable for use with outdoor appliances: store
indoors while not in use". Use only extension cords having an electrical rating not
less than the rating of the product. Do not use damaged extension cords. Examine
extension cord before using and replace if damaged. Do not abuse extension cord
and do not yank on any cord to disconnect.
Keep cord away from heat and sharp edges. Always disconnect the extension cord
from the receptacle before disconnecting the product from the extension cord.
When using an extension cord, observe the specification below:
WARNING: To reduce the risk of electrocution, keep all connections dry and off
the ground. Do not touch plug with wet hands.
Cable Length
Up to 25 ft.
(7.5 m)
Save theSe inStructionS
1
Wire gauge
12 AWG Outdoor
8- ENG
W
x