Protecting The Environment; Service Information - Stanley SCI12 Manual De Instrucciones

26 • ENGLISH
¡Important!To ensure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment (other
than those listed in thismanual) should be performed by
authorized service centers or other qualified organizations,
always-using identicalreplacement parts. Unit contains no
user serviceable parts inside.
ACCESSORIES
The performance of any power tool is dependent upon the
accessory used. STANLEY accessories are engineered
to high quality standards and are designed to enhance
the performance of power tool. By using STANLEY
accessories will ensure that you get the very best from
your STANLEY tool. STANLEY offers a large selection
of accessories available at our local dealer or authorized
service center at extracost.
Note: Accessory must be rated for use at speed equal
to or higher than nameplate RPM of tool with which it is
beingused.
Caution! The use of any non-recommended accesories
may be hazardous.

PROTECTING THE ENVIRONMENT

Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Stnley product
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
Batteries
This long life battery pack must be recharged
when it fails to produce sufficient power on jobs
which were easily done before.
At the end of its technical life, discard it with due
care for our environment:
f Run the battery pack down completely,
then remove it from the tool.
f Li-Ion cells are recyclable. Take them to your dealer
or a local recycling station. The collected battery
packs will be recycled or disposed of properly.

SERVICE INFORMATION

STANLEY offers a full network of company-owned and
authorized service locations. All STANLEY Service Centers
are staffed with trained personnel to provide customers with
efficient and reliable power tool service. For more information
about our authorized service centers and if you need technical
advice, repair, or genuine factory replacement parts, contact
the STANLEY location nearest you.
SPECIFICATIONS
Voltage
No-load speed
Max impact rate
Torque
Battery type
Tool holder
CHARGER
Input Voltage
AR, B2C
B2
B3
BR
Output Voltage
Output Current
Charge time
BATTERY
Voltage
Capacity
Type
* Maximum initial battery pack voltage
(measured without a workload) is 12 volts.
Nominal voltage is 10,8V.
SCI12
12V MAX*
0-2500/min (rpm)
0-3400 ipm (bpm)
110 Nm (972 in-lb)
Li-Ion
1/4" (6,35mm)
SC121
220V ~ 50Hz
220V ~ 60Hz
120V ~ 60Hz
127V/220V ~ 50-60Hz
12V MAX
1,25Amp
70min
SB12S
12V MAX
1,5Ah
Li-Ion