Removing The Secure Router 2330 Internal Pvim Module - Avaya 2330 Manual Del Usario

3. Ensure the PVIM slot is clear of debris. Protective tape is placed over the SO-DIMM
4. Holding the PVIM by its edges, insert the module in the slot on the Main Board,

Removing the Secure Router 2330 internal PVIM module

Use the procedure in this section to remove a PVIM module from the Secure Router 2330.
Prerequisites
• Ensure you have a Phillips #1 screwdriver.
• Ensure the Secure Router 2330 is powered off. You cannot hot swap internal
components.
• Ensure you have an antistatic bag or sheet available for the PVIM that you are
removing.
Procedure steps
1. Remove the Secure Router 2330 top cover. See Removing the Secure Router 2330
2. Locate the PVIM module. See the following figure for reference.
Regulatory Information
and PVIM slots during the manufacturing process; remove this tape if it is
present.
pushing down gently, but firmly, to fully seat the module. The release latches close
when the PVIM is properly installed.
top cover.
Voltage:
Do not open the Secure Router 2330 top cover while the unit is powered.
Secure Router 2330/4134 modules
August 2013 27