Safety Messages - Avaya 2330 Manual Del Usario

English
- Do not exceed the bend radius that is recommended for fiber-optic cable. The
acceptable bend radius for fiber-optic cable is ten times its diameter, or 2.5 to 5 cm
(1 to 2 in.). If you use a radius of less than the recommended bend radius, a loss of
signal integrity can result. Loss of signal integrity caused by incorrect bend radius is
difficult to diagnose.

Safety Messages

Voltage:
Risk of injury by electric shock
Before working on this equipment, be aware of good safety practices and the hazards
involved with electrical circuits. Use only power cords that have a grounding path. Ensure
that the switch is properly grounded before powering on the unit.
Warning:
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look
into an optical fiber or connector port. Always assume that fiber optic cables are connected
to a light source.
Warning:
Installation must be performed by qualified service personnel only. Read and follow all
warning notices and instructions marked on the product or included in the documentation.
Warning:
This product relies on the building installation for overcurrent protection. Ensure that a fuse
or circuit breaker no larger than 120 V AC, 15 A U.S. (240 V AC, 10 A international) is used
on the phase conductors.
Caution:
This device is a Class A product. In a domestic environment, this device can cause radio
interference, in which case the user may be required to take appropriate measures.
36 Regulatory Information
Comments? infodev@avaya.com
August 2013