Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
Procedure steps
1. Remove the Secure Router 4134 service access panel. See Removing the Secure
2. Locate the internal PVM connector slot. The following figure shows the location for
3. Ensure the PVM slot is clear of debris. Protective tape is placed over the SO-DIMM
4. Holding the PVM by its edges, insert the module in the slot on the Main Board,
32
Regulatory Information
Router 4134 service access panel.
Voltage:
Do not open the Secure Router 4134 service access panel while the unit is
powered.
installing the PVM.
and PVM slots during the manufacturing process; remove this tape if it is present.
pushing down gently, but firmly, to fully seat the module. The following figure shows
the proper orientation of the PVM in relation to the slot. If you are looking at the rear
of the router (with the service access panel removed), the key of the PVM is on the
left side.
Comments? infodev@avaya.com
August 2013
Publicidad
Tabla de contenido
