Attaching The Optional Mounting Flange To The Beacon; Table 2 Mounting Kit Hardware For Permanent Mounted Beacons - Federal Signal Spire 200 Instrucciones De Instalación Y Mantenimiento

Installation and Maintenance Instructions

Table 2 Mounting kit hardware for permanent mounted beacons

Qty.
Basic parts included with permanent mount beacons
3
3
Additional parts included with mounting flanges
3
3
3
Attaching the Optional Mounting Flange to the
Beacon
If the optional mounting flanges are to be used, you can either
attach them to the beacon before installation or attach the
flange to the vehicle first.
DO NOT DRIVE WITHOUT FIRST MOUNTING THE BEACON TO
THE FLANGE: Because vehicle roof construction and driving
conditions vary, do not drive a vehicle if the beacon is not
attached to the flange. The beacon could fly off the vehicle,
causing injury or damage. Repair of damage incurred because of
ignoring this warning shall be the sole responsibility of the user.
1. To attach the flange, locate the detent on the beacon and
one of the two detent notches on the flange.
2. Align the beacon as shown in Figure 1.
3. Push the beacon down completely and turn clockwise 1/8
turn until the detent locks in place.
8
Description
#8 Panhead Phillips Screw
#10 Panhead Phillips Screw
#10 Machine Screws, 1-3/4" long
#10 Machine Screws, 7/8" long
#10 Machine Nuts
Spire
Federal Signal www.fedsig.com
200 Beacon
™