Selecting The Color Order; Resetting The Beacon To The Default Settings - Federal Signal Spire 200 Instrucciones De Instalación Y Mantenimiento

3. The beacon switches from its initial setting to its opposite.
Single Color becomes Dual Color, or Dual Color becomes
Single Color.

Selecting the Color Order

You can set the order in which a beacon flashes. The order is
selected separately for Mode 1 or Mode 2.
To select the color order:
1. Activate the Mode for which this color feature is to be set.
2. Hold the green wire to the positive voltage source until the
beacon pulses four times, and then release the wire. The
beacon switches color from the initial setting to its opposite.
For example, a dual-color, amber-red beacon set to flash
amber then red will change to flashing red then amber. A
dual color, amber-red beacon set to the single color red will
become amber.

Resetting the Beacon to the Default Settings

To reset the beacon mode to the default settings, apply power
to the green wire while either Mode 1 or Mode 2 is powered.
Hold the wire to the power source until the beacon pulses six
times and then remove power. Repeat for each Mode you want
to reset.
NOTE: No change occurs if you remove power from the green
wire after five pulses and before the sixth pulse finishes.
Spire 200 Beacon
™
Federal Signal www.fedsig.com
Installation and Maintenance Instructions
17