Wiring The Beacon; Table 3 Wire Connections - Federal Signal Spire 200 Instrucciones De Instalación Y Mantenimiento

Installation and Maintenance Instructions

Wiring the Beacon

REVERSE POLARITY/MISWIRING: To avoid damage to the light,
ensure that the input voltage is the same as the voltage rating of
the light. Ensure that correct polarity is observed. Also ensure
that the unit is properly fused with a 2.0-amp fuse.
Color
Black
Red
White
Brown
Green
To wire the beacon:
1. Determine the required functions and the length of wires
needed to access them. A five-conductor cable can be
selected for a full-featured installation. For lengths up to
15 feet (5 m), use minimum 18 AWG (1 mm
over 15 feet, use minimum 16 AWG (1.5 mm
wiring the beacon, refer to Table 3 for the function of each
wire.
2. Strip 1/4 inch (5 mm) of insulation from the ends of the
installer-supplied wires.
3. Use insulated butt connectors to connect the wires to the
power cable of the beacon. Ensure that the connectors are
securely crimped and properly insulated.
4. Connect the end of the fuse holder to the positive (+)
terminal of the voltage source.
10

Table 3 Wire Connections

Description
Ground
Mode 1
Mode 2
Low Power
Program/
FSLink
Federal Signal www.fedsig.com
Connection Point
Battery Negative
Switched Positive
12-24 Vdc
Switched Positive
12-24 Vdc
Switched Positive
12-24 Vdc
12-24 Vdc
) wire. For lengths
2
) wire. Before
2
Spire 200 Beacon
™