Power Failure; Temperature Setting; Fume Temperature; Switching Off - Cadel RONDO Manual De Instalación, Uso Y Manutención

After a failed ignition the burning pot must be empty from the amassed pellets, before
starting the stove up again.
• Too much pellets in the burning pot, or humid pellet, or sooty burning pot make ignition difficult and
create dense white smoke which is harmful to health and can cause explosions on the combustion
chamber. It is therefore necessary not to stand in front of the stove during ignition stage if dense white
smoke is present.
If after some months the flame appears weak and/or orange colored or the glass tends
to blackens and the burning pot to become encrusted, clean the stove, clean the
fume conduit and the chimney flue.
10.8

POWER FAILURE

• After a black-out lower than 5 seconds, the stove turns back to the power which was settled.
• After a black-out of more than 5 seconds, the stove enters the "COOLING WAIT" phase. Completed this
phase, it starts automatically up with the different phases (see START UP page 68).
10.9

TEMPERATURE SETTING

• To modify the ambient temperature it is sufficient to press P1 and P2 keys according to the desired
temperature inside the menu "SET TEMP AMBIENT".
• To see the set temperature, press once P1 key.
10.10

FUME TEMPERATURE

To check the fume temperature at the exhaust it is sufficient to keep pressed P2 key.
10.11

SWITCHING OFF

To switch the stove off, keep pressed P4 key: the display shows "FINAL CLEANING". After about 10 minutes,
also the fume fan switches off (this happens always, independently if the stove is hot or cold). Then "OFF"
will be shown.
If the pellets are of bad quality (if contains sizing agents, oils, varnishes, plastic remains
or if it is mealy), deposits will form along pellets drop pipe during the running. When the
stove is switched off, these remains could form little hot coals that rising along the pipe
could reach the pellets on the hopper burning them and creating a thick and harmful
smoke inside the room. Please always keep the hopper closed with its own lid. If the
pipe is sooty, please clean it (see INTRODUCTION page 74).
10.12

CLOCK SETTING

• Press P3 key and then P5 key till underlining "SET CLOCK" menu (02).
• Press once P3 (DAY) and with P1 and P2 keys select the day of the week (Monday, Tuesday, Wednesday,
Thursday, Friday, Saturday, Sunday).
• Press for the second time P3 key (HOURS) and with P1 and P2 keys set the hour.
• Press for the third time P3 key (MINUTES) and with P1 and P2 keys select the minutes. Press for the fourth
time P3 key (DAY) and with P1 and P2 keys select the day of the month (1,2,3...29,30,31).
• Press for the fifth time P3 key (MONTH) and with P1 and P2 keys select the month:
• Press for the sixth time P3 key (YEAR) and with P1 and P2 keys select the year.
• To exit from the programme press P4 twice.
RONDÓ - MIKA
EN
69