Technical Specifications; Assembling The Bed - Thuasne MultiComfort II G2 Manual De Utilización

5

Technical specifications

Bed base:
Lowest position of bed
base
Highest position of bed
base
Overall dimensions
Idle weight
Maximum permitted load:
Maximal load of the lifting
pole:
Maximum load total
Heaviest sections of the
bed:
Head/foot of the bed
Back section :
Foot section :
Electrical category
Noise level
Maximum permitted
mattress height:
Mattress dimensions:
6

Assembling the bed

The bed must be assembled, used and dismantled only by well-trained, expert personnel. Look at figure 1
and follow these instructions.
Once the bed has been assembled, follow the checking instructions described in chapter 8.
6.1 Assembling the bed
There are several ways to assemble the bed depending the experience of the assembling person, the
ground and the necessary amount of physical strength. The following method is the easiest way considering
the physical strength.
Pay attention while assembling, that you treat the bed parts carefully. Place them carefully on the floor, to
avoid damaging the drives.
A. Place the head part of the bed against a wall and block the two castors by applying the brakes.
B. Stick the bed base of the head end and the head part together.
C. Ensure that the butterfly screws are fastened tight.
D. Position the foot part of the bed against a wall and block the two castors by applying the brakes.
E. Stick the bed base of the foot end and the foot part together.
F. Ensure that the butterfly screws are fastened tight
G. Release the brakes and push the foot and the head parts of the bed together.
H. Push both parts completely together and tighten firmly the butterfly bolts.
90 x 200 cm
40 cm
80 cm
105 x 214 cm
Bed: 84 kg
Lifting pole: 6,4 kg
Side rails: 9 kg
Accessories: 0,25 kg
Bed
Max. weight of the user:
135 kg
mattress 20 kg
accessories 15 kg
Total 170 kg
Lifting pole and triangle grip: 80 kg
80 kg
170 kg
Weight : 20 kg
Dimensions:
815 x 105 x 65 mm (Mantovani)
845 x 105 x 75 mm (Haydn)
70° (see figure 5)
0-30° thigh section (see figure 5)
0-20° leg section : 5 notched
stages (see figure 5)
Class II
Less than 65 dB
12 to 18 cm (MILANO side rails)
12 to 19 cm (PARIS side rails)
90 x 200 cm
.
32
Fig. 5 : Angles of the bed base