Disassembling The Bed; Function; Brakes - Thuasne MultiComfort II G2 Manual De Utilización

From there lead the cable between the two cross
tubes (figure 17) at the head section to the main
connection. You minimize the risk to cross the
main cables while moving the bed.
After finalisation of all tasks, check that, when moving through all bed adjustments the cables are not pulled
too tightly or squeezed, not get rubbed or trailing over the floor.
6.6

Disassembling the bed

1. Move the bed base and head- and leg-raising devices into the lowest position, namely the horizontal
position.
2. Remove the plug from the mains. Undo all electrical connections (adjustable height mechanism and
the leg-raising devices). Hand control unit and back rest device may stay plugged in. Wind the mains
connection cable to the U-shaped support located on the head of the bed for this particular purpose.
3. Then disassemble the bed by following the assembly instructions in reverse order.
While disassembling and transporting the bed moveable parts should be secured (e.g. with straps) to avoid
falling down and being damaged.
7

Function

The assembly and use of the bed normally require the following conditions to be met :
- Wall socket 240 V (UK) or 230 V (EEC), 50 Hz ;
- Flat, stable and horizontal floor in a dry room ;
- An available surface area of at least 2.5 m x 1.5 m, with a height of 2.2 m.
7.1

Brakes

Do not forget to block the castors by engaging the brakes prior to use.
Fig. 18: castor, not blocked
Push down for
fixation
36
Fig. 19: castor blocked with applied brake
Figure 17
Push forward
to loose