Installing The Appliance - EAS ELECTRIC EMH363CGB Manual De Instrucciones

o The edges of the hob must be a minimum distance of 60 mm from a side or
rear wall.
o 700 mm between the highest point of the hob surface (including the burners)
and the underside of any horizontal surface directly above it.
o 400 mm between the hob surfaces, providing that the underside of the
horizontal surface is in line with the outer edge of the hob. If the underside of
the horizontal surface is lower than 400 mm, then it must be at least 50 mm
away from the outer edges of the hob.
o 50 mm clearance around the appliance and between the hob surface and any
combustible materials.
o You must have a gap of at least 25 mm and at most 74 mm between the
underneath of the appliance and any surface that is below it.
- An oven must have forced ventilation to install a hob above it.
- Check the dimensions of the oven in the installation manual.
- The cut out size must obey the indication.

installing the appliance

For example:
1. Remove the pan supports, the burner lid and
2. Apply the sponge provided around the
3. Do not leave a gap in the sealing agent or
Bottom view
600
45 mm
flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
Take care that the Ignition devices and flame
supervision devices are not damaged in this
operation.
edge of the appliance.
overlap the thickness.
Sponge
The thickness of the sponge is 3 mm.
The width of the sponge is 10 mm.
EN-20
EN-20
V.3