Deactivation Of All Programs; Resetting Deactivation; Timer (Countdown Function) - PRG GT-ZSd-01 Manual De Operación

PROGRAMMING
Deactivation of individual programming
If there should be one or more switching functions that are temporarily not required, then
you can deactivate a program that has already been stored, without deleting the correspon-
ding switching data from memory.
In such cases, you only have to turn off the activation and the deactivation time.
1. Push on the PRG button, until you have reached the corresponding program location.
2. Then push the ON/OFF button, for deactivating the corresponding program. The symbol
„X" will be displayed and indicates that this program location is no longer active.

Deactivation of all programs

1. Push on the PRG button, to switch from the timer mode to the time-setting mode. The
weekday will blink on the display.
2. Push the ON/OFF button to deactivate all of the programs. The „X" symbol will be displayed,
showing that all the program locations are no longer active.
81
PROGRAMMING

Resetting deactivation

1. To reverse a deactivation, simply use the PRG button to select the corresponding program
location and then activate the desired program.
To reactivate all programs, select the time-setting mode.
2. Push the ON/OFF button for reactivating the function(s), after which the „X" symbol will
no longer be displayed.

Timer (countdown function)

This functions permits a targeted activation or deactivation of the attached equipment, for
periods ranging from 1 second, up to and including 23 hours, 59 minutes and 59 seconds.
#
Example:
You would like to leave an external device switched on for 1 hour, 10 minutes and 30
seconds.
82