Metra 99-5722 Instrucciones De Instalación página 11

Attention! This interface will work with models that are either amplified or non-amplified.
Please follow the instructions carefully for your model vehicle. Failure to do so will result in
either no sound, or low sound. If you are unsure if your vehicle is factory amplified or not, please
contact your local dealership.
For models with an amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
• If the aftermarket radio has a mute wire, connect the Brown wire to it. If the mute wire is
not connected, the radio will turn off when SYNC is activated.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Tape off and disregard the following (4) wires, they will not be used in this application:
Green, Green/Black, Purple, Purple/Black.
CONNECTIONS TO BE MADE
(CONT.)
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
From the 5722 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Blue wire to the power antenna wire.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
• Connect the Red and White RCA jacks labeled "RSE/SYNC/SAT", to the audio AUX-IN jacks.
• Disregard the Red and White RCA jacks labeled "FROM 3.5", they will not be used
in this application.
• Disregard the DIN jack, it will not be used in this application.
• Connect the White RCA jack labeled "SUBWOOFER", to the subwoofer out jack.
• Connect the Red RCA jack labeled "CENTER CHANNEL", to the center channel out jack.
Note: If this jack is not present on the aftermarket radio, just leave be. Only the center
channel speaker will be lost.
11
REV. 10/27/2020 INST99-5722