Movement WIRE CROSS 45 Manual Del Usaurio página 71

5
ASSEMBLY
STEP 13 - FIXING THE EQUIPMENT TO THE SOIL - RECOMENDATION
Movement designs its products to be stable when used. Because strength training is dynamic, we can not predict how the user will use the equipment. Therefore,
Movement recommends that the equipment be secured to a solid, level surface to stabilize and eliminate rocking or tipping. For some equipment, it is
attach the equipment to the ground.
• All equipment of the WIRE line is
• The use of accessories such as TRX, ropes, straps, chains, elastics, is
• It is the buyer's responsibility to adjust and install the equipment in accordance with the regional building codes;
• The anchor bolt should have a minimum of engagement on the concrete floor;
• The anchor bolt should not have any slack when it is placed in the hole;
• Do not reuse the anchor. The anchor bolt is designed only to be used once;
• When buying the anchor, take into account the height of the foot of the equipment;
• When buying the anchor, take into account the thickness of the counter.
METHOD OF ATTACHING THE EQUIPMENT TO THE GROUND WITH THE MOVEMENT KIT
The steps below describe the method of installing the anchor bolt for securing the equipment to the floor.
1
1- Drill the holes in the floor using the foot
as a guide.
4
3- Clean the hole
7
6 - After expansion of the sleeve remove
the nut and the washer.
TOOLS
Fixed wrench
RECOMMENDED
to be fixed to the ground;
2
5
4- Place the assembled anchor and
8
100%
REQUIRED the Wire line equipment is fixed to the ground;
adjust the expansion point.
7- Insert the component to be fixed.
Insert the bolt and washer
the tightening needed.
ATTENTION!
THE APPLICATION TORQUE MUST
BE 20 N.m
29
3
2- Drill the hole with the 9/16" drill
bit at a depth of 5.0 cm.
6
5- To insert the bolt, tighten it with
sufficient torque for expansion of the sleeve.
ATTENTION!
INADEQUATE TORQUE CAN CAUSE
DAMAGE TO THE EQUIPMENT AND/OR
ACCIDENTS TO THE USER.
RECOMMENDED to
Anchor with
prisoner