Sub-Zero ICBIW-30C Guia De Instalacion página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 10
INSTA L L AT IO N
Completion
T OP T R IM I N STAL L ATION
Identify the top trim strips by the notch on one end at the
bottom; this trim strip fits on the hinge side of the unit.
Insert the outer end of each trim strip behind the vertical
side trim. Engage the snap in the plastic side bracket and
slide the panel as far to the outside as possible. Refer to the
illustration below.
Rotate the inner end of each panel into the side flange of
the center shroud. Press on the trim strip to snap into place.
Refer to the illustration below.
Inner top trim.
Outer top trim.
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design, are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
KI CKPLATE INS TA LLATIO N
Position the kickplate and install using the two mounting
screws. Refer to the illustration below. Kickplate must
be removable for service. The floor cannot interfere with
removal.
A maximum 152 mm decorative kickplate can be attached
to the factory-installed kickplate. The two rows of vented
louvers can be covered if door panel is a minimum 102 mm
from finished floor.
To install a decorative kickplate, remove paper backing from
the magnets and attach decorative kickplate to magnets.
Magnets will allow the decorative kickplate to be removed,
if necessary.
Turn power on by touching
on the control panel.
MAGNET
SCREW
Kickplate installation.
9 0° D O O R S TO P
A 105° door stop is built into the hinges. To limit the door
to 90°, open the door slightly less than 90°, then use a
standard screwdriver blade to remove the existing clips from
each hinge. Locate the 90° clips from inside the plastic bag
containing product literature, then insert the 90° clips onto
each hinge. Refer to the illustration below.
CLIP
90° door stop.
WARNING
Follow all local laws when storing, recycling or dis-
carding unused refrigerators and freezers.
subzero.com
|
9

Publicidad

Tabla de contenido
loading

Tabla de contenido