MRA 4025066171019 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
1 Retaining plates, pair
4 Spacer sleeves, 3mm
4 O-rings, 4.5x1.5mm
4 Plastic discs 12x5x0.5mm
4 Fillister head screws, M5 x 16mm
4 Elastic nuts M5
2 Steel sleeves, black, 10mm
2 Washer, black, 16x8x1mm
2 Hexagonal protective cap M8
2 Allen screws, M8x45mm
Mounting the windscreen onto the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the top fork clamping screws.
3. Take the retaining plates [11476] provided and insert the 8x45mm Allen screw [11085] with
the washer [11036] through the hole on the retaining plate and slide the 10mm spacer
sleeve [10776] against it from the back. Then, place the rubber nuts [10629] onto the holes
(P1).
4. Now, mount the retaining plates onto the motorcycle (P2). Align the retaining plates and
tighten the screws only slightly.
5. Take the MRA windscreen and insert the M5x16mm fillister head screws with the plastic
washers through the holes. Place the 3mm spacer sleeves against this from behind and
secure these with the small O-rings [10992].
6. Now, mount the windscreen onto the motorcycle. OUR TIP: Press against the rubber nuts
from behind until the fillister head screw has caught.
7. Align the windscreen and the retaining plates and tighten all screws fully.
8. Tighten the fork clamping screws with 26nm.
9. Finally, place the protective caps [10454] onto the fastening screws [P3].
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Triumph Trident 660 2021-
Article No..
--- Allen key 3mm and 6mm
11476 Torque wrench
10872
10992
10635
10554
10629
10776
11036
10454
11085
2
Required tools