Quick PAJ 1T MSC Manual De Instalacion Y Uso página 13

The command meets standard EMC (electromagnetic compatibility). In any case correct installation is fundamental in or-
der not to affect its performance or interfere with operation of instruments found near it.
For this reason the command must be at least:
• 30 cm away from the compass.
• 50 cm away from any radio receivers.
• 1 m away from any radio transmitters (except for SSB).
• 2 m away from any radio transmitters SSB.
• 2 m away from the path of the radar beam.
Once the mounting position has been selected, follow the steps
given below:
• Remove the frame before fitting the PAJ 1T MSC.
• Place the drill template (provided) on the surface where the
command will be installed.
• Mark the center of each hole.
• Drill the hole for the back of the command with a 70 mm
diameter milling cutter.
• To fix the device on hard materials (fibreglass) drill the marked
centre of the four screws using a Ø 2.5-mm bit.
Use M3 screws (not supplied) to fix the device on metal sheet.
• Remove the template and any cutting burrs present at the
holes.
• Apply the adhesive gasket to the instrument.
• Put the command into place.
• Tighten the four self-tapping screws provided to secure the
command to the panel.
• The tightening torque of the four screws will vary according to
the material and thickness of the panel where the instrument
will be fitted. The screws should be so tightened as to
guarantee the proper sealing of the gasket.
• Insert the interlocking frame.
F
To remove the frame once the command is fitted,
press on the corners and lift.
PAJ 1T MSC REV001A
INSTALLATION
FRAME SELF-TAPPING
SCREW
COMMAND
GASKET
HOLE Ø 70 mm
EN
13