Selecting The Measurement Configuration: Analogue/ Digital Signal; External Units Power Supply - Promax US TV EXPLORER 2 User Manual

5.6

Selecting the measurement configuration: Analogue/ Digital signal

Measuring the characteristics of a channel depends, in the first place, on the type
of modulation: analogue or digital.
Use key [20] to switch between analogue and digital channels. Press the
[20] key to show the measurements CONFIGURATION menu and select the
Signal option by turning and pressing the rotary selector [1]. The Signal option allows
setting the type of signal to measure. When switching to a new type, the US TV
EXPLORER II activates the last measurement configuration used for that type of signal.
5.7

External Units Power Supply

The US TV EXPLORER II can supply the voltage needed to power the external
units (antenna preamplifiers, in the case of terrestrial TV, LNB in the case of satellite
TV, or IF simulators).
In order to select the supply voltage of the external units, press
the screen will display a functions menu labelled EXT. SUPPLY listing the choice of
voltages (which will depend on the band being used). Turn the rotary selector [1] to the
desired voltage and press to activate it. The following table shows the choice of supply
voltages:
Band
SATELLITE
TERRESTRIAL
MATV
Table 3.- External units powering voltages.
Page 32
USER'S MANUAL. US TV EXPLORER II
Powering voltages
External
5 V
13 V
15 V
18 V
24 V
13 V + 22 kHz
18 V + 22 kHz
External
5 V
13 V
15 V
18 V
24 V
[11] key, and
10/2007