Inverter Configuration; Heat Pump Software Updating - ECOFOREST ecoSMART e-system Manual Instalador

4.1. Inverter configuration

The hybrid inverter included with the e-system allows the configuration of a series of
parameters to optimize the efficiency of the device depending on the installation of self-
consumption that has been made.
From the electrical panel of the e-system you have access to the inverter configuration
screen. Please read carefully the inverter manual included with your e-system for the
correct configuration of the different parameters of the equipment.

4.2. Heat pump software updating

If you have purchased your ecoSMART e-system after your ECOFOREST heat pump, you
may need to upgrade the heat pump software.
In the version screen of the INFORMATION menu (Press
screen) you can check the software version of both e-system and ECOFOREST heat
pump. The version number Vxx_Bxx must match in both cases, as is indicated in the
following figure.
o
o
Dat
0.0%
Bo 6.24
Boot 4.05
Illustration 4.2. Information screen with software version of e-system (left) and ECOFOREST heat pump (right).
Otherwise, contact the ECOFOREST technical service, which will provide you with the
appropriate software version and indicate the steps required to update it.
BC15_EM_03_B04
02/10/15
25/02/14
04/02/13
Installer manual ecoSMART e-system
to quick access from the main
o
o BC15_HP_03_B04
Dat
Bo 6.24
Boot 4.05
EO fmw
EO Sv.v.
69
02/10/15
25/02/14
04/02/13
5.0
0.2