Equipment Connection; Start Up; Inspection, Maintenance And Cleaning; Filters - S&P CADT-D HE Manual De Instalación. Instrucciones De Uso

The user or installer should only connect the input and output tubes of the water
battery to the hot water closed circuit.
WATER BATTERY

6.5. EQUIPMENT CONNECTION

Before connecting the equipment, make sure that the rotating general switch on the elec-
trical panel is in the OFF position.
In order to see the wiring diagrams os the equipment, please consult the enclosed in-
structions for the mircroprocessor control.

7. START UP

Before starting up, we recommend carrying out the following checks:
- Ensure that there are no foreign bodies inside the device, and that all the components are
securely in place.
- Manually check that the fan does not come into contact with the sides.
- Check that the inspection flap is closed.
NOTE:
If there are no ducts at the mouths of a fan, a suitable protection network should be in-
stalled.
Check the earth connection.
The electrical connection should be completed by properly qualified people.

8. INSPECTION, MAINTENANCE AND CLEANING

8.1. FILTERS

The state of obstruction of the filters is monitored through the controller display (See
chapter "Use of the controller").
- Inspection through the unit sides:
Stop the device with the rotating main switch, turn the catch on the right/hand panel (Ex-
pelling side filter) to open it. Press the securing clips upwards to remove the filter. Repeat
the same operation for the left/hand panel (Impulsion side filter).
DIRECT INSTALLATION
13