Cebora PLASMA SOUND PC 70/T Manual De Instrucciones página 26

Air enters the power source at the rear and leaves it
through the grates on the front. Position the power source
in order to ensure a wide ventilation area and maintain a
distance of at least 1 m from any walls.
Do not stack the power source or place anything on it.
Position the power source on a mainly fl at surface with a
gradient of no more than 10°.
3.2 WELDING TORCH ASSEMBLY
After inserting the mobile fi tting M into the guard K, in-
sert it onto the fi xed fi tting J, by fully tightening the fi tting
collar M to prevent air leaks that could hinder effective
operation.
Do not dent the contact tip, do not bend the mobile fi tting
M pins.
Screw the guard K onto the panel.
3.3 START-UP
The machine must be installed by professional per-
sonnel. All connections must be carried out accord-
ing to current regulations, and in full observance of
accident prevention laws (CEI 26-36 /IEC60974-9
standard) .
Connect the gas supply to fi tting C making sure that the
system can deliver suffi cient fl ow and pressure to the
torch being used.
If the air is supplied from a compressed air cylinder, the
cylinder must be equipped with a pressure regulator;
never connect a compressed air cylinder directly to
the machine regulator. Pressure may exceed the reg-
ulator's capacity and it could explode.
Connect power cable A: the yellow-green lead of the
power cable must be connected to an effi cient earth sys-
tem; the remaining leads must be connected to the pow-
er supply line by means of a switch, located near the cut-
ting area if possible to permit fast deactivation in an emergency.
The capacity of the circuit breaker or fuses in line with
the circuit breaker must be the same as current I1eff con-
sumed by the device during cutting.
Max current I1eff consumed can be deduced by reading
the technical data on the device against available supply
voltage U1.
The cross-section of any extensions must comply with
maximum current consumption I1eff.
26
4. USE
When the device is turned on by means of knob B, the
display N shows:
For Item No 334-336
Information
Power Source
Version panel
Version control
Torch CP162C MAR 6m
- power source item number;
- fi rmware version installed in the panel board
;
- fi rmware version installed in the control board
;
- type of torch fi tted
(CP 70C MAR/DAR; CP 162C MAR/DAR)
- length of the welding torch when fi tted (6/15 m)
For Item No 337
Information
Power Source
Version
Build
Torch CP162C MAR 6m
- power source item number;
- installed fi rmware version;
- fi rmware development date,
- type of torch fi tted;
- length of the fi tted welding torch
Note: torch type and length are automatically recognised.
A few seconds later, display N shows one of the screens
described below.
In general, knob H is used to select the various items,
namely:
- CUT, SELF RESTART,
MARK working modes
- working current;
- working pressure;
- cutting gas;
- material
336
04
01
337
04
Feb 20 2017
GOUGE and SPOT