Assisted Procedure - MasterCool 69789 Instrucciones Para El Uso

ASSISTED PROCEDURE

WARNING:
DO NOT STOP THE RECOVERY PROCESS. Stopping the recovery process will definitely cause damage to the Compressor and perhaps other
components. It will also cause the machine to fill up with unprocessed liquid refrigerant which will disable the machine from further use.
Damage due to STOPPING THE RECOVERY PROCESS could void the warranty.
In the assisted procedure mode, all the operations can be performed individually. The values for the quantity of gas recovered, quantity of oil
recovered, vacuum time, quantity of oil reintegrated, and quantity of gas charged into the system are automatically printed at the end of each single
operation.
From main menu:
Select the ASSISTED PROCEDURE, the following screen is displayed (only if the hardware for hybrid vehicles is installed in the machine).
Press F4 ↵ to confirm STANDARD VEHICLE or press the DOWN ARROW ↓ and then F4 ↵ to select HYBRID VEHICLE.
NOTE: When HYBRID VEHICLE is selected the OIL phase of the AUTOMATIC PROCEDURE is disabled and the HOSE FLUSHING operation is activated.
The following message appears:
Press F4 ↵ to continue
18
▶
REF CHARGING
■
Open high and low
service port valves
Turn on A/C system
F1: to continue
REF CHARGING
■
ALLOW HIGH AND LOW
PRESSURE TO EQUALIZE
CLOSE ALL VALVES
F2: WHEN COMPLETE
F1
F2
F3
SELECT
■
Standard vehicle
Hybrid vehicle
Gas Filling
warning
using pag oil or
■
tracer in hybrid
vehicles can damage
the compressor
Gas Filling
F4
F5
F6
↵
↑
↓
xxg
↵
↑
↓
xxg