GYS 4T Manual Del Usuario página 15

Translation of the original instructions
SPREADER SETUP
The Spreader (C) is used when the Ram (B) is too long to fit between the stationary side and the damaged area.
1. Cie an the end of the Hose (21) and the in let on the Spreader (C).
2. Unscrew and save the Dust Covers located on the end of the Hose (21) and Spreader (C).
3. Attach the Hose (21) to the Spreader Wedge (C), as shown below:
RAM SETUP
Note: When positioning the Ram (B) use a smaller attachment on the side that is to be bent instead of the stationary
side. If the stationary side is in danger of being bent or damaged, place a block of wood or other material behind the
Flat Base (3) to distribute pressure over a greater area.
When extension tubes and/or offset attachments are used, the rated capacity is always reduced by
50% for each tube or offset attachment connected.
• Clean the end of the Hose (21) and the inlet on the Ram (B). Unscrew and save the Oust Covers located on the end
of the Hose (21) and Ram (B).
• Attach the Hose to the Ram.
• Assemble attachments as shown below:
HYDRAULIC CYLINDER KIT
Pump (A)
Hose (21)
EN
Spreader (C)
15