GYS 4T Manual Del Usuario página 18

Translation of the original instructions
TO OPERATE RAM (B) :
1. Connect the appropriate Base (3, 4, 7) to the stationary
side of the Ram (B), and connect the appropriate head
to the pushing end of the Ram.
Note : When repairing larger body panel dents such as
a dented door, fender or quarter-panel use the Rubber
Head (10) on the pushing end.
2. If using the Flange Base (4) or Flange Head (5) : Thread
the Flange Base onto the Rame completely and align
the Flange Head to do it. The Flange Base and Flange
Head must only be uses together to prevent off-center
load.
TO OPERATE SPREADER (C) :
1. Place the Spreader (C) so that the hinged (pushing)
arm is resting against the part to be moved and the sta-
tionary arm is resting against non-movable base.
WARNINGS :
1. Once both ends have made contact, move as far away as possible and continue to slowly apply pressure to the
damaged area until the desired bend has been made. Caution ! Keep hands away from contact area tight spaces.
The tool may slip and cause injury.
2. When the damaged area has been bent to the desired position, slowly turn the Release Valve (26) counterclockwise
to release the hydraulic pressure and remove the Ram (B) or Spreader (C).
3. Clean all hydraulic ports and cover them with clean Dust Covers to prevent contamination and damage.
18
HYDRAULIC CYLINDER KIT
3. Position the Ram (B) so that the Base is resting
4. Aim the pushing head towards the area that needs to
Note : To prevent damage, do not overextend the Ram.
2. Carefully hold the Spreader in position and apply pres-
against a frame member opposite the damage area.
It must also be in line with the direction in which the
damaged area needs to be pushed. The vehicle body
part must be stronger than the area to be bent or it
may be damaged. A block of wood or towel may be
used to protect the body part.
be repaired, and slowly apply pressure with the Pump
(A).
sure with the Pump (A).
EN