salmson LRE Serie Instalacion Y Puesta En Servicio página 100

English
No. Designation
4.2.3.0 Countdown, pump
cycling
4.2.4.0 Remaining time
until pump kick
4.2.5.0 Mains On counter
4.2.6.0 Pump kick counter
4.3.0.0 States
4.3.1.0 Base-load pump
4.3.2.0 SSM
4.3.3.0 SBM
90
Type Symbol Values/explanations
Time to pump cycling in h (at a
resolution of 0.1 h)
Time until the next pump kick
(after the pump has had a 24 h
standstill (e.g. via External off), it
will be automatically operated
for 5 seconds)
Number of switching-on proce-
dures of the supply voltage
(each occasion the supply volt-
age is established after an inter-
ruption is counted)
Number of pump kicks carried
out
The value display statically
shows the identity of the regular
base-load pump.
The unit display statically shows
the identity of the temporary
regular base-load pump.
ON
State of the SSM relay if there is
no fault signal
OFF
State of the SSM relay if no fault
signal is present
ON
State of the SBM relay if a readi-
ness/operation or mains On sig-
nal is present
OFF
State of the SBM relay if no read-
iness/operation or mains On sig-
nal is present
SBM
Run signal
Display conditions
Shown only for double pump
master and internal pump
cycling Can be set in the ser-
vice menu <5.1.3.0>
Only displayed if pump kick is
activated
Only displayed if pump kick is
activated
Only displayed for double
pump master
Salmson 11/2017