Cleaning And Disinfecting Instruction - Gima OXY-100 Guía De Uso

Ocultar thumbs Ver también para OXY-100:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

39

8.2 Cleaning and Disinfecting Instruction

- Surface-clean sensor with a soft cloth by wetting with a solution such as 75%
isopropyl alcohol, if low-level disinfection is required, use a 1:10 bleach solution.
- Then surface-clean by a dampened cloth and let it air dry or wipe it with a cloth.
High-pressure disinfection cannot be used on the device.
Do not immerse the device in liquid.
Disposal: The product must not be disposed of along with other
domestic waste. The users must dispose of this equipment by
bringing it to a specific recycling point for electric and electronic
equipment.
For further information on recycling points contact the local
authorities, the local recycling center or the shop where the product
was purchased. If the equipment is not disposed of correctly,
fines or penalties may be applied in accordance with the national
legislation and regulations.
GIMA WARRANTY CONDITIONS
Congratulations for purchasing a GIMA product.
This product meets high qualitative standards both as regards the material
and the production. The warranty is valid for 12 months from the date of
supply of GIMA.
During the period of validity of the warranty, GIMA will repair and/or replace
free of charge all the defected parts due to production reasons. Labor costs
and personnel traveling expenses and packaging not included. All components
subject to wear are not included in the warranty.
The repair or replacement performed during the warranty period shall not
extend the warranty.
The warranty is void in the following cases: repairs performed by unauthorized
personnel or with non-original spare parts, defects caused by negligence or
incorrect use.
GIMA cannot be held responsible for malfunctioning on electronic devices or
software due to outside agents such as: voltage changes, electro-magnetic
fields, radio interferences, etc.
The warranty is void if the above regulations are not observed and if the serial
code (if available) has been removed, cancelled or changed.
The defected products must be returned only to the dealer the product was
purchased from. Products sent to GIMA will be rejected.
ENGLISH

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido