Medtronic MiniLink REAL-Time Manual Del Usaurio página 4

Bleeding may occur after inserting the sensor. Make sure that the site is not bleeding
before connecting the transmitter to the sensor.
• If bleeding occurs, apply steady pressure with a sterile gauze or clean cloth at the
insertion site until bleeding stops. After bleeding stops, connect the transmitter to the
sensor.
• If bleeding persists after three minutes, remove the sensor and discard. Insert a new
sensor in a different location.
Contact the 24 Hour HelpLine if you experience any adverse reactions associated with
the transmitter or sensor.
Magnetic fields
Do not expose your transmitter to MRI equipment, diathermy devices, or other devices
that generate strong magnetic fields. If your transmitter is inadvertently exposed to a
strong magnetic field, discontinue use and contact the 24 Hour HelpLine for further
assistance.
X-rays, MRIs, diathermy devices, and CT scans
If you are going to have an X-ray, diathermy treatment, CT scan, MRI, or other type of
exposure to radiation, disconnect your transmitter and remove your sensor before
entering a room that contains any of this equipment.
Important information about airport security systems, and using your insulin pump on an
airplane, can be found on the Emergency Card. Be sure to carry the Emergency Card
provided when you are traveling.
Precautions
Establish a rotation schedule for choosing new sensor sites. Avoid sites that are
constrained by clothing, have scar tissue, or are subject to rigorous movement during
exercise.
Only use the watertight tester with the transmitter. Do not use any other test plug.
Do not twist the tester while it is attached to the transmitter. This will damage the
transmitter.
Do not allow water, or any other liquid, to come in contact with the tester when it is not
connected to the transmitter. A wet tester can cause damage to the transmitter.
Do not clean the o-rings on the tester, as this can damage the o-rings.
Radio communication notice
This device complies with the United States Federal Communications Commission (FCC)
and international standards for electromagnetic compatibility.
-2-