vitapur VWD9506W Manual De Uso Y Cuidado página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. To access the reservoir system, you must remove the top cover on the dispenser (See Fig. 17) by removing the two
Philips screws located at the rear of the cover (See Fig. 17A).
4. Carefully lift off the top cover.
5. Remove the black reservoir cover by carefully pulling upward (See Fig 17B).
6. If using a Vitapur water dispenser cleaning solution, please follow the manufacturer's instructions provided with the
cleaning kit. If using a pre-mixed solution of 15ml (1 tbsp) bleach with 4.5L (1.2 gal) of hot water, fill the reservoir
and let stand for 20 min.
7. Press both dispensing taps until the cleaning solution stops flowing (collect the cleaning solution into a container/
bucket).
8. Flush the reservoir with clean water and press both dispensing taps until
water stops flowing (collect the water into a container/bucket).
9. To drain any remaining water from the reservoirs, remove (unscrew) the
drain cap and plug located at the rear of the dispenser (See Fig. 18).
Collect the water into a container/bucket. IMPORTANT: Remember to
re-install the drain cap and plug and tighten (See Fig. 18).
10. Re-install the reservoir cover by pressing down firmly.
11. Re-install the dispenser top cover and secure using the two Philips screws.
12. Re-connect the power cord.
13. Re-open the manual shut-off valve (you will hear water entering the system
which will stop automatically when the appropriate water levels are reached).
14. Place a container under the water spigots and press both dispensing buttons (separately) to make sure water is
flowing normally from each side.
OPERATING INSTRUCTIONS:
IMPORTANT NOTE: Your Vitapur® water dispenser is designed with a special "safety" feature (float switch mechanism)
that controls activation/operation of the "Kettle Feature" hot water tank heating system. If no water is present and/or low
water levels are detected inside the internal reservoir system, activation/operation of the hot water heating system is not
possible. Likewise, if the hot water heating is operational and water is being drawn simultaneously causing water levels
to drop below safe levels, hot water tank operation is automatically terminated until normal water levels are restored,
at which time you must "manually" re-activate the hot water heating system by pressing the kettle feature (red) button.
NOTE: Operation of the cold water system is not affected by this safety feature.
CHILD RESISTANT SAFETY SWITCH:
DO NOT ALLOW CHILDREN TO USE THE HOT WATER DISPENSING
BUTTON WITHOUT PROPER AND DIRECT SUPERVISION.
To prevent hot water from being dispensed accidentally and possibly harming
a child, the hot water dispensing button can only be operated when the child
resistant safety switch is activated. To dispense hot water, push/hold the child
safety switch sideways (in the direction of the arrow located on the switch)
from right to left, then press/hold the hot water button (as soon as water starts
flowing you can release the child safety switch) until the desired amount of hot
water is dispensed. Upon releasing the hot water button, the child safety switch
automatically re-engages to the locked position.
10
Fig. 18
Child
resistant
safety
switch

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Vwd9506bls

Tabla de contenido