Insert the water line into the valve until is stops (See Fig. 4) slide both the compression nut and compression ring toward
the valve and tighten the nut firmly using a wrench. CAUTION: DO NOT OVERTIGHTEN (See Fig. 5).
Fig. 4
8. The water dispenser is equipped with a manual "shut off" valve installed on the rear side of unit (See Fig. 6A) for
easy access in case of an emergency.
9. Connect the incoming water line into the open side of the manual shut off valve (See Fig. 6B). This valve utilizes
"quick-connect" type water line fittings (no tools required). Simply insert the end of the water line into
the shut off valve and until it stops. WARNING: DO NOT OPEN THE WATER SUPPLY LINE AT THIS STAGE.
(See installation of Filter).
10. To disconnect (remove) the water line from the shut-off valve, you must first remove the blue locking "c-clip"
(See Fig. 14) by pulling it forward.
11. To release the water line, simply press and hold the "white" outer collar surrounding the line (See Fig. 15) while at
the same time pulling the water line out. NOTE: The locking "c-clips" must always be installed "prior" to installation
of the water lines.
INSTALLATION OF FILTER:
For hygiene purposes, the filter included inside the water dispenser has not been factory installed. It has been shipped
in its original shrink-wrapped package. The filter is located behind the lower front panel of the dispenser. To access the
filter;
• Remove the drip tray by pulling it forward. (See Fig. 7)
• Remove the Phillips screw securing the lower panel. (See Fig. 8)
• The filter is secured by 2 retaining clips. Remove, and unwrap the filter. (See Fig. 9 & 9A)
Fig. 7
Fig. 5
Fig. 8
7
B
Fig. 9
A
Fig. 6
Fig. 9A