Cleaning And Maintenance - vitapur VWD9506W Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DISPENSING HOT WATER:
WARNING: The hot water is heated to approximately 90°C (194°F). Temperatures above 52°C (125°F) can cause
severe burns from scalding. DO NOT ALLOW CHILDREN TO USE THE HOT WATER DISPENSING BUTTON
WITHOUT PROPER AND DIRECT SUPERVISION.
The "Kettle Feature" (hot water) dispensing system on this unit is designed to save energy
and money. Conventional hot water dispensing systems operate 24/7 regardless of water
usage. The on demand "Kettle Feature" activates the hot water system ONLY when the "Kettle
Feature" (red) button is activated delivering steaming hot water in less than 3 minutes.
To stop/cancel the "Kettle Feature" during a cycle, simply press the "Kettle Feature" (red)
button a second time and the red LED light will turn off.
1. Press the "Kettle Feature" (red) button and the red LED light will start flashing to signify the heating system is
operational. The heating cycle takes approximately 3 minutes. When the heating cycle is completed, the red LED
light will change from "flashing" to a steady "on" condition (meaning water has reached optimum temperature).
2. To dispense hot water, place cup/glass under dispensing spigot, push/hold the child safety switch to the left and
press the hot water dispensing button (with red line indicator), until the desired amount of water is dispensed. The
red LED light will turn off automatically when the hot water is dispensed. NOTE: The hot water temperature (factory
default setting) is not adjustable on this unit.
DISPENSING COLD WATER:
The cooling system on this unit is designed to activate automatically as soon as the power cord is connected.
1. When the blue LED light is "off" the cooling cycle is operational. When the blue LED is light is "on" the cooling cycle
(compressor) is off and the cold water has reached optimum temperature.
2. To dispense cold water, place cup/glass under dispensing spigot, push/hold the cold water dispensing button (with
blue line indicator) until the desired amount of water is dispensed.
ADJUSTING THE TEMPERATURE (COLD WATER ONLY)
The temperature of the cold water reservoir is controlled by a cooling thermostat
located at the rear of the dispenser. The factory default setting of the thermostat
is "mid-point" (medium) on the thermostat scale. By turning the thermostat set
screw (See Fig. 19) the temperature can be adjusted. Turn the dial clockwise
(using a screwdriver) between "L" (warm) and "H" (colder) until the desired
temperature is reached. If water is not being properly dispensed, there could be
possible ice build-up in the reservoir due to the thermostat being set too cold. If
this happens, slowly rotate the dial counter clockwise to a warmer setting.

CLEANING AND MAINTENANCE:

See "Initial Product Cleaning" and follow steps 1 ~ 13.
CLEANING THE DRIP TRAY (NOT DISHWASHER SAFE):
To remove, pull the drip tray towards you. Drain and clean. The drip tray should
be emptied and cleaned regularly to remove spotting and mineral deposits.
11
Fig. 19
grill
drip
tray

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Vwd9506bls

Tabla de contenido