Assembly Instructions; Important - Harbor Breeze 00960 Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

1. Determine mounting method to use.
Downrod Mount (standard or angled ceiling)
IMPORTANT: lf using the angle mount, check
to make sure the ceiling angle is not steeper
than 20°.
2. Remove and discard the five rubber inserts
and five mounting screws from the underside
of the motor housing (D).
3. Remove the mounting bracket (A) from the
canopy (B) by loosening the four screws
on the top of the canopy (B). Remove the
two non-slotted screws and save.
1
2
D
Rubber
insert
and screw
3
A
Remove and
save
but do not
remove
B
6
ASSEMBLY INSTRUCTIONS
4. Install the mounting bracket (A) to the
outlet box (not included) using the two
screws provided with the outlet box.
Securely tighten the two screws.
5. Remove pin and clip from downrod
assembly (C) and save.
6a. STANDARD DOWNROD INSTALLATION
Insert downrod assembly (C) through
canopy (B). Thread wires from the motor
assembly (D) through downrod assembly
(C).
Loosen
4
Outlet box
5
Clip
Pin
6a
B
C
7
A
C
D