Publicidad
Idiomas disponibles
Idiomas disponibles
Key:
Check speed on start
Key:
Encoder resolution /
material feed per encoder
rotation
Key:
Material speed
Intermittent Mode
Mode
Key:
Back speed
Key:
Unit of print offset
Key:
Print offset
Key:
Print position
Key:
Layouts/cycle
Off: Material speed is only checked if the set offset value is taken into consideration. The print
start signal can be given although the material is not yet moving. However, until the end the
material speed has to be inside the valid speed sector as otherwise the print order is cancelled.
On: Material speed is checked at print start signal. Is the material speed outside of the valid
speed sector then the start signal is ignored.
Default: Off
Indication of resolution of used encoder and material feed per rotation of encoder in mm. These
settings help measuring the material speed.
The material feeding per encoder rotation corresponds for instance, in a 1:1 translation between
the encoder and the roller, to the roller circumference.
Indication of material speed (only for reading purposes).
Value range: 12 ... 93 mm/s.
Selection of operating mode (number of pieces, continuous mode, test mode, direct start).
Indication of back speed of print mechanics after print end in mm/s.
Value range: 50 ... 600 mm/s.
Selection for the unit of print offset.
Settings possible either in mm or ms.
Indication of distance of the layout (res. the first layout in case more layouts per cycles are to be
printed) to the zero point of machine.
Value range: 0 ... 999 mm
Default: 0 mm
Indication of start position of print carriage in mm.
Value range: 0 ... 43 mm
Default: 3 mm
Indication of the number of printed layouts per print start (cycle).
Value range: 1 ... 25.
English
Flexicode
119
Publicidad
Capítulos
