Front Panel Features - Numark 5000FX Manual De Inicio Rápido Para El Usuario

1. XLR/¼" Combo Microphone Input Jack: Connect your DJ mic at this location. Note
that this input and the rear DJ Mic input jack share the same channel controls. To use the
DJ MIC, the Input Selection Switch on Channel 1 must be set to DJ MIC.
2. Input Selector: This toggles select which input source is routed to the channel.
3. Channel Gain Knob: This rotary control adjusts the pre-fader input level. This
adjustment should be made so the meters are just peaking in the red section of the PFL
meter.
4. Pre Fader Level Meter (PFL): Accurately shows level of incoming channel audio.
Accurately match channel levels using the pre-fader gain and EQ controls before mixing
them together. The idea is to match PFL input levels. You should avoid trying to match
the input with the stereo output meter.
5. Channel Treble: This rotary control adjusts the high-tone level.
6. Channel Middle: This rotary control adjusts the middle-tone level.
7. Channel Bass: This rotary control adjusts the low-tone level.
8. Channel Fader: This adjusts the level sent to program mix. For best results, set the
fader near the bold line. This allows headroom adjustment in the mix.
9. FX/Sampler Buttons: Routes channel audio to the effects processor and sampler. This
is explained further in the FX section.

FRONT PANEL FEATURES

5