Optika Italy B-510 Serie Manual De Instrucciones página 11

5. Insert both eyepieces into the tubes of the optical
head. (Fig. 12)
• One of the two eyepieces is equipped with
a crosshair for centering the entire optical
system. It is advisable to insert the eyepiece
with crosshair in the right eyepiece sleeve.
• Condenser is pre-installed in the factory. To
remove the condenser use an Allen wrench
1,5mm diam and operate on the locking screw
placed on the right side of the condenser holder.
6. Screw each objective into the thread of
the nosepiece,
magnification. (Fig. 13)
7. Insert reflected light polarizer ⑦. (Fig. 14)
8. Remove the dummy slider from Bertrand lens ⑧
and insert the analyzer ⑨. (Fig. 15 - 16)
clockwise with increasing
⑧
Page 11
F F ig. 12 ig. 12
F ig. 13 F ig. 13
F ig. 14 F ig. 14
⑦
F ig. 15 F ig. 15