Putting Into Operation - Abicor Binzel MF1 Instructivo De Servicio

MF1
1
10
9
1 Interface as compressed-air clutch
2 Torch interface
3 Frontdrive MF1 provided with wire actual
value encoder
4 Cable assembly interface
Fig. 2 Functional Description

6 Putting into operation

Risk of injury due to unexpected start-up.
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power supply.
• Cut off the gas supply and coolant supply.
• Pull the mains plug.
Danger of crushing
Hands can be pulled in and crushed by turning wheels.
• Do not reach into moving wheels.
NOTICE
• Please take note of the following instructions:
• The system may only be installed and put into operation by authorized personnel (in Germany see
• When delivered with the robot mount CAT, an insulation is provided. If an alternative supporting
2
8
5 Cable assembly clutch
6 Interface as compressed-air connection
7 19-pin connection of cable assembly
control lead
DANGER
WARNING
 2 Safety on page EN-3
TRBS 1203).
device is used, the housing must be attached to it insulated.
3 4
8 CAT robot mount
9 4-pin control lead connection
10 Interface WH
11 Interface ABIROB
6 Putting into operation
5
6
7
®
W
EN - 9