General Safety Instructions - Torin BIG RED TRA8205B Manual Del Propietário

SAFETY MARKINGS
WARNING!
1. Study, understand, and follow all instructions before operating this device.
2. Ensure the jack is lubricated and in good working order before each use.
3. Do not exceed rated capacity. This is a lifting and pulling device only. Do not use to support load.
4. Ensure the work area is flat and sufficient to hold the load. Shifting of the load or work area can cause the
jack to loose stability and shift or fall suddenly.
5. Use chocks or a blocking device on load before using jack.
6. Lift only on areas of a vehicle as specified by the vehicle manufacturer.
7. Only use adaptors and chains supplied by the manufacturer.
8. Ensure all chains or adaptors used have a rated load greater than that of the jack.
9. Keep head and hands clear of the range of movement of the jack handle. Unexpected shifting of the load
or loss of grip on the handle could cause it to snap back.
10. Always keep handle against the standard bar when changing the reversing latch. This could cause sudden
movement of the handle.
11. Do not use this jack for any use other than the manufacturer specified usage.
12. Failure to heed these markings may result in personal injury and/or property damage.

GENERAL SAFETY INSTRUCTIONS

WARNING!
• Always inspect the jack before using, replace if damaged or malfunctioning.
• Do not remove any of the labels from the jack.
• Always ensure the jack is used on a hard flat and level surface
• Never lift any load over the rated capacity.
• Always center jack under load.
• Never allow load to tilt on the jack as the jack may kick out causing injury to the operator and/ orcause the
load to fall.
• When using more than one jack to lift a load, each jack must have the same lifting capacity of the entire
load being lifted.
• Never force the Lifting Runners past the safety stop, as the Runner may come out of the jack and could
result in personal injury and properly damage.
• Always keep the Steel Standard Column lubricated for ease of operation and to prevent against rust.
4