Product Assembly - cecotec HYDROBOOST 10200 LIBERTY PRO Manual De Instrucoes

ENGLISH
In order to charge the battery, plug the charger into a suitable power outlet.
A red light will indicate that the battery pack is correctly connected with the charger and that
it is charging.
When the battery is fully charged, the green light will turn on. Unplug the battery.
If the battery starts flashing a red light, it means there is a battery failure. In this case, remove
the battery and reinsert it. If the battery is correctly charged but the red light still flashes, the
battery may be invalid.
Indicator status
Red light is always on
Green light is always on
Flashing red light

3. PRODUCT ASSEMBLY

Step
Removing the battery.
Charging the battery. Check the charging
instructions for further details.
Battery indicator
Installing the battery.
Installation
Installing the multi-function nozzle
Note: When the nozzle is installed, shake
the nozzle gently to check if it's correctly
installed.
Connecting the water inlet's hose
Note: When the hose is installed, shake
the nozzle gently to check if it's correctly
installed.
Operation
Select the operating mode.
The device can operate under two modes:
High mode, which is used for cleaning the
most stubborn dirt, and the Energy-saving
mode (ECO), to clean the easier dirt.
38
HYDROBOOST 10200 LIBERTY PRO
Status description
Charging
Finished charging
Battery failure
Figure
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10