Operation - cecotec HYDROBOOST 10200 LIBERTY PRO Manual De Instrucoes

ENGLISH
Assemble the detergent bottle to remove by
spraying on the most stubborn dirt. Adjust the
detergent-spray rate by turning the knob.
Use only soap for pressure washers.
The proportion of water and soap should
be: 5,4 % of soap and 94.6 % of water, 1:19
approximately.
Try the soap where it will not be too visible
before using the device.
Open the bottle for soap and fill it with water
and soap.
Cover it again.
Remove the lance.
Install the bottle for soap in the spray gun.
Let the soap act on the surface for some
minutes. In the meantime, scrub the dirtiest
zones with a brush. Do not let the soap touch
the surface.
Remove the bottle for soap from the spray
gun and replace it for the lance. You can also
remove it from the tip of the lance.
Clean the soap from the surface.
Note: Wash the bottle for soap with water
after each use.
Final rinse
Start the final rinse from the bottom to
the top. Make sure the surface is correctly
rinsed and that the dirt has completely been
removed.
Assemble a long nozzle (lance) to clean the
dirt on the ground or in walls. Adjust the fan's
spray angle by rotating the tip.
Cleaning the inlet's connector.
Cleaning the inlet filter.

4. OPERATION

Adjusting water stream
The angle of the water stream coming out of the nozzle can be adjusted with the pulverising
nozzle by rotating the tip. This will vary the water pattern from approximately a 0° narrow
40
HYDROBOOST 10200 LIBERTY PRO
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 18
Fig. 19