cecotec HYDROBOOST 10200 LIBERTY PRO Manual De Instrucoes página 42

ENGLISH
When spraying water against a surface, maximum impact is reached when the water strikes
the surface head on. However, this type of impact tends to cause dirt particles to imbed in the
surface, thereby preventing the desired cleaning action.
The optimum angle for spraying water against a cleaning surface if 45 degrees.
Spraying water against a surface at this angle provides for the most beneficial impact force
combined with efficient removal of debris from the surface.
Distance from cleaning surface
The impact force of the water is increased as the pulverising nozzle is moved closer to the
surface.
How to avoid damaging surfaces
Damage to cleaning surfaces occurs because the impact force of the water exceeds the
hardness of the surface. The impact force can be varied by controlling the three previously
noted items. Never use a narrow high impact stream on a surface that is susceptible to damage.
Avoid spraying windows with a narrow high impact stream as this may cause breakage.
The surest way to avoid damaging surfaces is to follow these steps:
Before triggering the gun, adjust the pulverisingng nozzle to a wide stream.
First, follow the distance and angle instructions above.
Vary the spray angle, stream type and the distance to the cleaning surface until optimum
cleaning efficiency is achieved without damaging the surface.
Cleaning process
Surface preparation
Clean the area of furniture and make sure all windows and doors are closed tight. Also, make
sure that all plants and trees near the cleaning area are protected by a drop cloth.
Initial high-pressure rinse
Spray the cleaning surface with water to clear off any dirt or grime that may have collected on
the surface. Before triggering the gun, adjust the pulverisingng nozzle to a wide stream and
slowly adjust it to the desired stream. This will avoid applying too much concentrated spray to
the surface which could cause damage.
Final rinse
Start the final rinse at the bottom and work upward. Make sure the surface is thoroughly
rinsed and that al dirt is removed.
Shut down
Release the trigger.
Remove the water supply.
Warning:
42
HYDROBOOST 10200 LIBERTY PRO