How To Select The Mask Type; Smartstart; Starting Treatment; Stopping Treatment - ResMed VPAP Auto 25 Manual Del Usuario

How to Select the Mask Type

Scroll to MASK and select
you require. The following table shows the setting that should be selected for each
mask:
Settings
ULTRA
MIR FULL
ACTIVA
SWIFT
STANDARD
MIRAGE

SmartStart™

If your clinician has enabled SmartStart/Stop, your device will start automatically
when you breathe into your mask and stop automatically when you take your mask
off.

Starting Treatment

1
Make sure the power is on.
The product name is displayed briefly on the LCD screen, then the standby (Ramp/
Settle) screen appears. The key and LCD backlights also turn on.
2
Fit your mask as described in the mask user instructions.
WARNING
!
A mask should not be used unless your VPAP device is turned on and operating
properly.
3
To start therapy, simply breathe into the mask or press
flowing slowly and will build up to the operating pressure in about 15 seconds.
4
Lie down and arrange the air tubing so that it is free to move if you turn in your sleep.

Stopping Treatment

To stop treatment at any time, remove your mask and press
clinician has enabled SmartStart/Stop, simply remove your mask and treatment will
end.
Note: SmartStart/Stop will not work if:
•
you have a Full Face Mask; or
•
your clinician has enabled Leak Alert.
6
. Press
Mask
Ultra Mirage Nasal Mask
Ultra Mirage II Nasal Mask
Mirage Liberty Full Face Mask
Mirage Quattro Full Face Mask
Ultra Mirage Full Face Mask
Mirage Activa Nasal Mask
Mirage Swift Nasal Pillows System
Mirage Swift II Nasal Pillows System
Mirage Vista Nasal Mask
Mirage Micro Nasal Mask
Mirage Nasal Mask
or until you see the setting
. Air will begin
or if your