Using The Vpap Auto 25 And Vpap St; Setting Up Your Vpap - ResMed VPAP Auto 25 Manual Del Usuario

•
Up to 15 L/min in CPAP , S, ST and T modes.
At a fixed flow rate of supplemental oxygen flow, the inhaled oxygen concentration
will vary, depending on the pressure settings, patient breathing pattern, mask
selection, and the leak rate.
WARNING
!
Always use the ResMed Oxygen Connector Port when adding supplemental
oxygen at the flow generator outlet.

Using the VPAP Auto 25 and VPAP ST

Setting up your VPAP

1
Connect the power cord to the socket at the rear of your VPAP.
2
Plug the other end of the power cord into the power outlet.
3
Connect one end of the air tubing firmly onto the air outlet.
4
Connect the assembled mask system to the free end of air tubing.
For information on assembling your mask, see your mask manual.
1
WARNING
!
•
Make sure the power cord and plug are in good condition and the
equipment is not damaged.
•
Only ResMed air tubing should be used with the device. A different type of
air tubing may alter the pressure you actually receive, reducing the
effectiveness of your treatment.
•
Blocking the hose and/or air inlet of the device while in operation could lead
to overheating of the device.
2
3
Using the VPAP Auto 25 and VPAP ST
4
3