Assembly - Shindaiwa AH2510 EVC Manual Del Propietario - Operador

Assembly

Prior To Assembly
Before assembling, make sure you have
all the components required for a com-
plete unit:
Engine assembly
Outer tube/cutter assembly
Strap
Connect the Outer Tube to the Powerhead
1. Place the powerhead on a clean, flat
surface, spark plug facing up.
2. Use the 4 mm hex wrench to loosen the
tube clamp screw.
3. Slide the outer tube into the tube
clamp until the tube bottoms. If instal-
lation is difficult, rotate the outer tube
or main shaft slightly until you feel
the mainshaft splines engage with the
powerhead.
CAUTION!
Do not force the shaft tube into the
powerhead! Excessive force can dam-
age the shaft tube and mainshaft.
4. Position the outer tube so that the
gearcase output shaft is facing left on
muffler cover.
Connect the Throttle Cable
1. Loosen the air cleaner cover knob and
remove the air cleaner cover.
2. Push the throttle cable through the
cable adjustor.
NOTE
Make sure the ribbed cable tube is on
the left side of the engine before connect-
ing the throttle cable.
3. Connect the bullet-shaped end of the throt-
tle cable to the throttle lever on top of
the carburetor.
4. Connect ignition leads.
CAUTION!
Wiring runs must not interfere with
throttle operation.
6
Kit with this manual and tool kit for rou-
tine maintenance.
Cutter blade cover
Carefully inspect all components for
damage.
Outer Tube
Trigger
Housing
Connect outer tube to
powerhead
5. Slide the outer tube into the powerhead
until the throttle grip just contacts the
tube clamp.
6. Tighten the clamp screw firmly.
Filter
Cover
Loosen air cleaner cover knobs
Connect ignirtion leads
The terms "left", "left-hand", and "LH";
"right", "right-hand", and "RH"; "front" and
"rear" refer to directions as viewed by the
operator during normal operation.
Clamp Screw
Mainshaft
Grip
Hex
Wrench
End of
throttle cable
Push the throttle
cable through the
cable adjustor
Ignition Lead
IMPORTANT!
Spark Plug
Tube Clamp
Tube Clamp
Throttle cable
Cable
Adjuster
Connect
end of
throttle
cable here