Starting The Engine - Shindaiwa AH2510 EVC Manual Del Propietario - Operador

Starting the Engine

Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, "I" for ON or START and "O" for OFF or STOP.
WARNING!
Never start the engine from
the operating position.
1. Slide the ignition switch to the "ON"
position.
2. Set the throttle lever to the "fast idle":
a. Squeeze the throttle lever toward
the handgrip on the shaft tube.
b. Depress and hold the throttle lock
button.
c. While depressing the throttle lock
button, release the throttle lever.
3. Press the primer bulb until fuel can
be seen flowing in the transparent
return tube.
IMPORTANT!
The primer system only pushes fuel
through the carburetor. Repeatedly press-
ing the primer bulb will not flood the
engine with fuel.
4. Set the choke lever to the CLOSED
position if engine is cold.
5. While holding the outer tube firmly
with left hand. Use your other hand
to slowly pull the recoil starter handle
until resistance is felt, then pull quickly
to start the engine.
CAUTION!
Do not pull the recoil starter to the end
of the rope travel. Pulling the recoil
starter to the end of the rope travel
can damage the starter.
WARNING!
The cutting attachment may
move when the engine is started!
When the Engine Starts...
After the engine starts, allow the
engine to warm up at idle 2 or 3 min-
utes before operating the unit.
After the engine is warm, pick up the
unit and clip on the shoulder strap, if
so equipped.
IMPORTANT!
Throttle Lock
Button
Slide ignition to ON
Set the choke lever to the CLOSED position
6. When the engine starts, slowly move
the choke lever to the "OPEN" posi-
tion. (If the engine stops after the initial
start, close the choke and restart.)
7. Operating the throttle will automatically
disengage the fast idle setting.
IMPORTANT!
If the engine fails to start after several
attempts with the choke in the closed
position, the engine may be flooded with
fuel. If flooding is suspected, refer to the
"Starting a Flooded Engine" section of
this manual.
Advancing the throttle makes the cutting
attachment move faster; releasing the
throttle permits the attachment to stop
moving. If the cutting attachment con-
Primer Bulb
ON
Press primer
bulb...
Close
choke
...and pull recoil
starter handle
upward
After engine starts, move choke to OPEN
position
tinues to move when the engine returns
to idle, carburetor idle speed should be
adjusted (see "Adjusting Engine Idle".).
Return Tube
Hold
the unit
Make sure the
attachment is clear
of obstructions!
Open
9