Installing The Dryer; Step 1: Position And Level The Dryer Unit; Step 2: Connect Dryer Unit Exhaust System - Alliance Laundry Systems D009C Instalación/Operación

Installation

Installing the Dryer

Step 1: Position and Level the Dryer Unit

For further assistance, refer to section on Location
Requirements.
Install dryer before washer. This allows room for
attaching exhaust duct.
Install the four rubber cups found in the accessories
bag.
Place the dryer in position, and adjust the legs until the
dryer is level from side to side and front to back.
1
3
1 Dryer Base
2 Level
3 Leveling Leg
4 Rubber Cup
Figure 5
Step 2: Connect Dryer Unit Exhaust
System
For further assistance, refer to sections on Location
Requirements and Dryer Exhaust Requirements.
WARNING
A clothes dryer produces combustible
lint. To reduce the risk of fire and
combustion gas accumulation the dryer
MUST be exhausted to the outdoors.
14
2
D690I
4
W116
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
DO NOT use plastic or thin foil ducting.
G
Locate dryer so exhaust duct is as short as
G
possible.
Be certain old ducts are cleaned before installing
G
your new dryer.
Use 4" (10.2 cm) diameter rigid or flexible metal
G
duct.
The male end of each section of duct must point
G
away from the dryer.
Use as few elbows as possible.
G
Use duct tape or pop-rivets on all duct joints.
G
Ductwork that runs through unheated areas must
G
be insulated to help reduce condensation and lint
build-up on pipe walls.
Install backdraft dampers in multi-dryer
G
installations.
Failure to exhaust dryer properly will void
G
warranty.
.
D690I
DO
NOTE: Venting materials are not supplied with the
dryer (obtain locally).
DON'T
D354I
Figure 6
D356I
510975