Pre-Operation Checks - Subaru EH72 FI Manual De Instrucciones

3. PRE-OPERATION CHECKS

STD-type
Oil gauge
Oil
gauge
Upper
level
Lower
level
5W
10W
Single
grade
Multi
grade
-20 -10 0
Ambient
temperature
-4 14 32
Option
Oil
gauge
Upper level
Lower level
Oil
gauge
Upper
level
Lower
level
20W
#20
#30
#40
10W-30
10W-40
10 20 30
40
50 68 86
104
CHECK ENGINE OIL
Before checking or refilling engine oil, be
sure the engine is not running and is located
on a stable, level surface.
If the oil level is below the lower level
■
line on the oil gauge, refill with the
proper oil (see table) to the upper
level.
OIL CAPACITY : 1.55 liter
When filling oil in the engine, keep the
■
engine level and fill the oil up to the
upper mark of the oil gauge. Measure
the oil level with the oil gauge plugged
in position.
After an oil change, run the engine,
■
and recheck the oil level. The oil level
may drop a little as the oil fills the oil
filter. Fill the oil up to the upper mark of
the oil gauge.
Change oil if it is contaminated.
■
(See Section 8 Maintenance Schedule.)
Use 4-stroke automotive detergent oil
■
of API service class SE or higher grade
(SG, SH or SJ is recommended).
If multi-grade oil is used, oil
■
consumption tends to increase when
the ambient temperature is high.
− 5−
(DAILY)