Optional Swivel Installation (Not Supplied); Wall Mounting; Standard Swivel Installation (Optional) - RISCO Group WL X312 Instrucciones De Instalación

CAUTION NOTICE
Changes or modifications not expressly approved by RISCO Group may void the user's authority to
operate this equipment.
Simultaneous transmissions from two different units may cause message interference resulting in loss
of information.
The communication quality of this unit may be affected by its surrounding environment. Nearby
electrical equipment may interfere with its normal operation.
The operation of this unit must, therefore, be tested at each installation since its transmission quality
may vary as a result of operational conditions.
NOTE:
DIP Switch 1 should be in ON position to enable LED indications (regardless during the first 20 minutes after power
up).

Optional Swivel Installation (Not Supplied)

Please follow the instructions below for mounting the detector with the Swivel:
1. Open WL X312 front cover (Unlock C1, Figure 1).
2. Release internal base (Unlock I1, Figure 2).
3. Remove back tamper from the internal base (see the "Changing Back Tamper Position" paragraph
on page 7) and connect it to S5 (Figure 8, Detail A) on the Standard Swivel.
4. Select the mounting installation as follows:
NOTE:
Ensure that you see the engraved UP mark on the upper front face of the swivel.

Wall Mounting

1. Insert back tamper wires through the Swivel Wires Passage (Figure 8, Detail B).
2. Secure swivel to the wall through holes S1, S3, S6 and S8.
Detail A
Standard Swivel
S1
S8
3. Connect the external base to the swivel using the dedicated snaps (Figure 9).
10
S2
S4
S5
S6
Tamper
(see Detail C)
Installation Manual
Detail B
W1
S1
Figure 8
Snaps
S2
S3
Detail C