Troubleshooting - Silverline 103597 Traducción Del Manual Original

GB

Troubleshooting

Problem Possible cause Solution
Mains circuit breaker operated or fuse blown Check circuit is capable of required current then reset mains circuit
No power
Internal fuse blown Have fuse replaced by a qualified electrician
During use the welder stops Duty cycle exceeded and Over-Heat Indicator (6) is
Leave the welder for 20-30 minutes to cool down
working illuminated
Incorrect current setting Adjust Current Dial (3)
Wrong electrode rod/stick Replace electrode rod/stick
Poor weld
Check Earth Clamp (8). Ensure there is no grease, paint or other surface
Poor earth connection on workpiece
coating that would cause a bad electrical connection with the workpiece
8