Insert, Remove The Modelling Light; Connect To Power Supply; Switch The Device On And Off - Walimex Pro Newcomer 100 Manual De Instrucciones

7. Insert, remove the
modelling light
WARNING
Posterior danger of bursting of flash
tube through skin oil
Never touch the flash tube with your bare
hands!
1
2
1 Modeling Lamp
2 Socket
1. Switch off device.
See Switch on and off of device.
2. Plug off power cord.
3. Let the device cool down.
WARNING
Danger of burning on reflector, modeling
lamp and flash tube. Please let the device
cool down for approx. 30 minutes.
4. Insert the modelling light:
• When the protection cap is mounted:
Demount protection cap.
See Demount and mount protection cap.
• Plug the modelling light carefully into the
socket.
36
5. Remove the modeling lamp:
• Pull the modelling light carefully out of the
socket.
• Mount protection cap. See Demount and
mount protection cap.

8. Connect to power supply

WARNING
Only connect the device to an earthed
socket.
1. Switch off device.
See Switch the device on and off.
2. Compare the local power supply with the
connected load of the device. If the values
differ, please contact info@walimexpro.de
or tel. +49 843294890.
3. Connect the power cord with the socket
on the device and with the power socket.

9. Switch the device on and off

1. When the protection cap is mounted:
Demount protection cap.
See Demount and mount protection cap.
WARNING
Danger of fire through heat accumulation.
Never use the device with mounted protec-
tion cap.