Switch The Audio Button On And Off; Prepare And Adjust Flash Trigger - Walimex Pro Newcomer 100 Manual De Instrucciones

10.3 Switch the audio button on and off

1. Switch on device.See Switch the device
on and off.
2. Switch on audio signal:
• Press push-button AUDIO.
The LED AUDIO lights.
A short beep can be heard when reaching
the adjusted flash output.
3. Switch off audio signal:
Press push-button AUDIO.
• The LED AUDIO goes out.
• After triggering a flash, the modeling lamp
goes out for a while and lights up again,
when the device has reached the adjusted
flash output again.
• A short beep can be heard when reaching
the adjusted flash output.
10.4 Prepare and adjust flash trigger
Prepare flash trigger through camera
NOTE
Please note the user information of the
camera manufacturer for flash synchroni-
sation.
1. Connect sync cord (included in delivery)
with the connecting socket on the device.
2. The other end of the sync cord should be
connected with the PC jack socket of the
camera.
Prepare flash trigger through remote
receiver (optional)
NOTE
Please note the user information of the
remote receiver manufacturer.
Connect the cable of the remote receiver with
the socket for the sync cord.
38
Switch on and off of flash trigger through
built-in photo cell
The photo cell enables the device to trigger
through:
• another external device
• on-camera flash devices with integrated
pre-flashes
1. Switch on device.
See Switch the device on and off.
2. Switch on photo cell:
Press push-button SLAVE.
The LED SLAVE lights.
3. Switch off photo cell:
Press the SLAVE button, until it goes out.
Flash triggering via the integrated radio
receiver with the walimex pro remote
control Excellence.
Adjusting the channels on the studio flash.
You can choose from 16 different channels
(F0, F1, F2, F3, ... , FF).
1. Press the SLAVE button on the studio
flash for about 4 sec.
2. The display shows "C..". Press the SLAVE
button once again, to access the adjust-
ment "F.." (radio channel).
3. Use the arrow keys to adjust the corres-
ponding channels.
4. Press the SLAVE button once again for
approx. 5 sec to save the selected chan-
nel. Or wait approx. 15 seconds, until the
display changes to the start page.
Adjusting channels on the remote control
(option)
1. Open the battery compartment cover
2. Adjust the studio flash to the remote
control by displacing the pins accordingly.